IPCS INCHEM Home
CHLOROPENTAFLUOROETHANE
(cylinder)
ICSC: 0848
Peer-Review Status: 26.03.1998 Validated
1-Chloro-1,1,2,2,2-pentafluoroethane
Fluorocarbon 115
CFC 115 
CAS #: 76-15-3 RTECS #: KH7877500
UN #: 1020
EINECS #: 200-938-2
    Formula: C2ClF5 / CClF2-CF3
Molecular mass: 154.5

TYPES OF
HAZARD /
EXPOSURE
ACUTE HAZARDS / SYMPTOMS      PREVENTION      FIRST AID / FIRE FIGHTING
FIRE Not combustible. Heating will cause rise in pressure with risk of bursting. Gives off irritating or toxic fumes (or gases) in a fire.    In case of fire in the surroundings, use appropriate extinguishing media. 
EXPLOSION     In case of fire: keep cylinder cool by spraying with water. 
 
EXPOSURE      
Inhalation Suffocation. See Notes.  Use ventilation.  Fresh air, rest. Artificial respiration may be needed. Refer for medical attention. 
Skin ON CONTACT WITH LIQUID: FROSTBITE.  Cold-insulating gloves.  ON FROSTBITE: rinse with plenty of water, do NOT remove clothes. Refer for medical attention . 
Eyes See Skin.  Wear safety goggles or eye protection in combination with breathing protection.  First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention. 
Ingestion      

SPILLAGE DISPOSAL
PACKAGING & LABELLING
Ventilation. NEVER direct water jet on liquid. Personal protection: chemical protection suit including self-contained breathing apparatus.   
EC Classification
 
UN Classification
UN Hazard Class: 2.2 
GHS Classification
 

EMERGENCY RESPONSE SAFE STORAGE
Transport Emergency Card: TEC (R)-20G39.  Fireproof if in building. Cool. 

IMPORTANT DATA
Physical State; Appearance
ODOURLESS COLOURLESS COMPRESSED LIQUEFIED GAS. 

Physical dangers
The vapour is heavier than air and may accumulate in lowered spaces causing a deficiency of oxygen. 

Chemical dangers
Decomposes on contact with hot surfaces or flames. This produces toxic fumes including hydrogen chloride and hydrogen fluoride. 

Occupational exposure limits
TLV: 1000ppm, 6320mg/m³ as TWA; (ACGIH 1997). 

Routes of exposure
The substance can be absorbed into the body by inhalation. 

Inhalation risk
A harmful concentration of this gas in the air will be reached very quickly on loss of containment. 

Effects of short-term exposure
Rapid evaporation of the liquid may cause frostbite. 

Effects of long-term or repeated exposure
 


PHYSICAL PROPERTIES ENVIRONMENTAL DATA
Boiling point: -39°C
Melting point: -106°C
Relative density (water = 1): 1.3
Solubility in water: none
Vapour pressure, kPa at 20°C: 797
Relative vapour density (air = 1): 5.3
Octanol/water partition coefficient as log Pow: 2.4  
This substance may be hazardous to the environment. Special attention should be given to its impact on the ozone layer. 

NOTES
High concentrations in the air cause a deficiency of oxygen with the risk of unconsciousness or death.
Check oxygen content before entering area.
Turn leaking cylinder with the leak up to prevent escape of gas in liquid state.
Arcton 115, Freon 115, Frigen 115, Genetron 115, Kaltron 115, and Refrigerant R 115 are trade names. 

ADDITIONAL INFORMATION
 

IPCS
International
Programme on
Chemical Safety
WHO ILO EC Prepared in the context of cooperation between the International Programme on Chemical Safety and the European Commission
© IPCS 2004-2012
LEGAL NOTICE Neither the EC nor the IPCS nor any person acting on behalf of the EC or the IPCS is responsible for the use which might be made of this information.


    See Also:
       Toxicological Abbreviations